TR2 Large Tank Nozzle
For Tanks Over 300 Litres
Top mounted rinse nozzles allow multiple rinses using a fraction of the total tank volume. On spraying equipment the rinse volume is typically 10% of tank capacity per rinse, depending on the size and extent of boom plumbing. Used in conjunction with a clean water tank this gives operators a quick and effective method of rinsing out in the field.
TR2 nozzles operate at flow rates of at least 50 litres/min and minimal pressure.
Rotor and boss are molded in polypropylene/acetyl. Spindle, nut and washer are stainless steel. End load is carried by a nylon thrust washer.
Fitting Information
Two nozzles mounted under the tank roof are usually adequate for tanks up to 2500 litres, depending on tank shape. Suspending the nozzles up to 30 cm below the tank roof dramatically increases wash radius, allowing tanks of 5000 litres or more to be rinsed by two nozzles. More can be installed provided each is supplied with at least Rotacraft Extension 50 L/min. Wash pattern covers an arc from 15 to 120 degrees from the vertical up axis, allowing flexibility in mounting position relative to the tank roof. The threaded boss can either be bulkhead fitted, passing through the roof with external plumbing, or be connected to plumbing fixed inside the tank. Thread 1″ NPT(M).
Benefits
- Less risk of pollution
- No internal access required for rinsing
- Encourages timely and thorough cleaning out
- Minimum downtime
Rinsing Applications
- Sprayer tanks
- Chemical tanks
- Tankers
- Industrial blenders
- Organic composters
- Storage tanks
- Reusable drums
- Rental tanks
- Service trucks
C1-T Small Tank Nozzle
For Containers & Tanks Under 500 Litres
The C1-T is suitable for rinsing smaller tanks and containers where the available flow rate is limited or less flow is required to achieve desired rinsing. The addition of a dispersion collar converts the C1 into a tank rinse nozzle suitable for tank sizes up to 500 litres, or larger if using more than one nozzle. Lateral projection is up to 1 m with minimal droop, continuing to over 1.5 m. Minimum flow recommended for the standard C1-T is 13 litres/min at 14 PSI. A lower pressure version, C1-T Lo, can be specified that functions down to 10 PSI delivering 10 liters/min.
Fitting Information
The C1-T can be fitted either way up. Inverted installation close to the tank roof allows tidier plumbing, but for elongated tanks or where the roof is ribbed or otherwise uneven the nozzle performs best mounted upright (ie. projecting upwards). Thread ½” NPT(F).
Benefits
- Less risk of pollution
- No internal access required for rinsing
- Encourages timely and thorough cleaning out
- Minimum downtime
Rinsing Applications
- Sprayer tanks
- Chemical tanks
- Water bottles
- Industrial blenders
- Organic composters
- Storage tanks
- Reusable drums